Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.

Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

---

The latest 4O3A Genius Product Software and Firmware

If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Ron Koenig ✭✭✭

• Activity
• Posts3
• Comments60

• Re: Workaround for antenna gain reset in 3.5.8

  Ron Koenig

  August 2023
  Alan, The way it is supposed to work, and did until 3.3 is... If you have RX A set @ +24 because you have a low gain RX antenna ANT1 (RX) set to +8 normally used on Yagi.... When you Swap between the…
  2

• Re: Workaround for antenna gain reset in 3.5.8

  Ron Koenig

  August 2023
  So would an Icom. But I'd prefer that the radios just work as advertised and critical Defects stop being introduced.
  2

• Re: Manually Connect to 6600M at Specific IP?

  Ron Koenig

  March 2023
  We can only Dream of having Acess to our radios like the Mac users.
  1

• Re: V. 3.4.21 AM Carrier

  Ron Koenig

  March 2023
  2

• Re: Question on Audio Delay when using DAX

  Ron Koenig

  October 2022
  Dave, It's Tolerance Stacking. If ALL Stations were 0.0 DT then it would only depend on the stations and propagation. the .3 is cumulative, it adds to an existing DT offset of the other station.…
  1

Previous Next